Electric power industry consulting
In 6-500 kV networks, single-core cables with XLPE insulation are widely used. Such cables have conductive screens. In such screens, if they are grounded at both ends, AC 50 Hz currents are induced in normal mode and active power losses occur. This leads to additional heating of the XLPE, a decrease in the long-term permissible
The reliability of cable lines is catastrophically dependent on the quality of installation work. Therefore, we can only be glad that there are a large number of experts all over the world who do their job accurately and precisely. Certainly, some of them may even be called as perfectionists. However, in my opinion, there is
If you are communicating with a person who puffs out his cheeks and says that he is perfectly familiar with the screens cross-bonding of single-core high voltage cables, then ask him next simple question – “What is the difference between two types of screens cross-bonding shown on schemes (a) and (b)?” There is type “123-312”
High voltage cables have an outer sheath. It is very important to ensure that sheath does not have serious damage. Otherwise, water may get into the cable, which in a few years will lead to a short-circuit of main XLPE-insulation. The sheath tests are performed by applying a DC of 10 kV between the cable
The photo shows cable termination of the single-core cable, which was overheated due to high currents induced in the screen and the armor. As far as you know, for single-core cables, armor can only be made of non-magnetic materials, and the photo shows aluminum allow armor that tightly covers the cable from the outside. Why
The photo shows a standard box for grounding of single-core cable screens. Such boxes are placed close to the cable terminations. Looking at the photo, we can see that the lid of the box has about 30 bolts. The question arises – do we really need this? The answer is no, we don’t need it.
Traditionally, the concept of “transposition” was used mainly for overhead lines (OHL) with a voltage of 330 kV and higher. For OHLs, the concept of “transposition” means a periodic change in the relative position of the three phase wires ABC. However, the situation has changed after the appearance of single-core cables with XLPE-insulation – the
When using single-core 6-500 kV cables, various grounding schemes of screens are known. However, regardless of the scheme, it is recommended to connect cable screens to the ground at the ends of the line using special boxes. They are useful for personnel safety and convenience of testing the outer sheath of single-core cables. There are
Let me pay attention to one very common mistake that can be very expensive. In the construction of a single-core cables, the main elements are the core and XLPE-insulation. The metal screen (Cu, Al) and the outer sheath of the cable are usually perceived as auxiliary elements of the cable. As a result, people carry
The photo shows the ordinary cable termination of 10 kV, which was overheated due to high currents induced in the screens. We can see traces of excessive heating at the junction of the screen with its grounding wire, caused by significant currents passing there. The quality of the screen and wire connections is a separate