Electric power industry consulting
At the ends of the cable line, there are cable terminations. Metallic screens of cables are removed from terminations to the outside, where they are connected in accordance with selected bonding/ grounding scheme. For example, the figure shows the high voltage cable line with one-sided grounding of screens. To have this scheme, metallic screens, with
Designing a cable line is an interesting process that resembles moving in a circle. The fact is that in order to select cables, we need the correct values of the short-circuit current (1.1) and the steady-state current (1.2). Such currents can only be calculated using information about the impedances of the cable line (R1, X1,
Let me please start a new series of posts about cable lines, scheduled for 2024, with a comic comparison of the cable pulling process with the fishing. This is the real story that happened a couple years ago with 110 kV cable when it was pulled in a hilly city. For that 110 kV cable,
High-voltage cables must have a conductive metal screen (sheath). The selection of the screen cross-section is very important. Without selecting the screen cross-section (and bonding/grounding scheme), it is impossible:✅ To ensure the resistance of the cable screen to fault (short-circuit) currents.✅ To perform a thermal calculation of the cable line and select the core cross-section.
High voltage cable terminations are usually installed vertically. This allows you:✅ To ensure the absence of mechanical influences bending the termination under its own weight and the weight of the cable.✅ To ensure high-quality filling of the termination with dielectric oil (not relevant for terminations of dry-type or gas-type). However, sometimes, for various reasons, the
If the cable is laid not in the ground, but on some structures, then it usually needs to be fixed. This is necessary, for example, so that during the passage of short-circuit currents through the cable, the forces that arise do not move the cable from place to place. A huge number of different versions
If you are communicating with a person who puffs out his cheeks and says that he is perfectly familiar with the screens cross-bonding of single-core high voltage cables, then ask him next simple question – “What is the difference between two types of screens cross-bonding shown on schemes (a) and (b)?” There is type “123-312”
High voltage cables have an outer sheath. It is very important to ensure that sheath does not have serious damage. Otherwise, water may get into the cable, which in a few years will lead to a short-circuit of main XLPE-insulation. The sheath tests are performed by applying a DC of 10 kV between the cable
The photo shows cable termination of the single-core cable, which was overheated due to high currents induced in the screen and the armor. As far as you know, for single-core cables, armor can only be made of non-magnetic materials, and the photo shows aluminum allow armor that tightly covers the cable from the outside. Why
There are a huge number of different types of transition towers between cable and overhead lines. The photo shows one of the HV types which is used on the territory of the UK. There are similar examples from around the world. As you can see, the equipment of the transition tower is surrounded by a