Electric power industry consulting
The sheath of high-voltage cables sometimes has a semiconductive layer (SC). Such a layer is believed to allow for better control of the condition of the outer sheath of the cable. For example, the presence of such a layer allows to check the cable outer sheath while the cable is on the drum. For this,
On AC 50 Hz lines built with single-core cables, induced (circulating) currents and associated power losses occur when the screens are solidly bonded. These currents and losses become especially dangerous when phases:➡️ have an increased screen cross-section (say, more than 50-70 mm2);➡️ arranged not in a trefoil, but in row, at a distance from each
The Internet has a lot of photos from real facilities where cable lines are laid, and such photos are interesting to study. There were several photos where a pipe was laid along the trench, from which flexible tubes connected to numerous vertical rods extend. There was no doubt that we had a water pumping system
Copper (Cu) and aluminium (Al) are the two main materials for the manufacture of conductive elements (cores and screen) of cables of all voltage classes. When choosing between Cu and Al, we have to compare them, and not in words, but numerically. For example, we know at least the following numbers comparing the properties of
Single-core cables are used in both high-voltage and medium-voltage (MV) networks. In both cases, the cables have the same problem – the presence of induced (circulating) currents in solidly bonded screens. To solve the problem, there are other bonding types:👉 Single-point bonding of the screens.👉 Cross-bonding of the screens. Despite the fact that problem with
If a short circuit occurs on the line, the line is switched off. However, what to do next depends on the type of the line:1️⃣ overhead line;2️⃣ cable line;3️⃣ mixed line, having both overhead and cable sections. 1️⃣ OVERHEAD LINEFor an overhead line, up to 60-90% of faults are associated with short-term overlaps of air
Sometimes optic fibre is embedded in power cables. Such a fibre may be located in a metal protective tube among the wires of the screen. The photo shows an example of such a cable, where 4 metal tubes are placed at once, partly to reserve each other (since fibre is very fragile). Why is an
For modern cables of 6-500 kV voltage classes, cross-linked polyethylene (XLPE) insulation is the most common. The properties of XLPE are such that if water molecules penetrate the insulation, they become a source of electric field distortion there, which contributes to the development of insulation defects called “water trees”. The appearance of water inside the